Redundant controller 369-HI-0-M-0-0

EnerVista 369 Setup software: Setup and monitoring software provided free with each relay.
RRTD: Remote RTD Module. Connects to the 369 Relay via a fibre optic or RS485 connection. Allows remote metering and programming for up to 12 RTDs.
F485: Communications converter between RS232 and RS485 / fibre optic.
Interfaces a PC to the relay.
CT: 50, 75, 100, 150, 200, 300, 350, 400, 500, 600, 750, 1000 (1 A or 5 A secondaries)
HGF: Ground CTs (50:0.025) used for sensitive earth fault detection on high resistance grounded systems.
515: Blocking and test module. Provides effective trip blocking and relay isolation.
DEMO: Metal carry case in which 369 is mounted.
FPC15: Remote faceplate cable, 15′.

1. The 369 Relay order code at the time of leaving the factory.
2. The serial number of the 369 Relay.
3. The firmware installed at the factory. Note that this may no longer be the currently
installed firmware as it may have been upgraded in the field. The current firmware revision can be checked in the actual values section of the 369 Relay.
4. Specifications for the output relay contacts.
5. Certifications the 369 Relay conforms with or has been approved to.
6. Factory installed options. These are based on the order code. Note that the 369 Relay
may have had options upgraded in the field. The actual values section of the 369 can
be checked to verify this.
7. Control power ratings for the 369 Relay as ordered. Based on the HI/LO rating from
the order code.
8. Pollution degree.
9. Overvoltage category.
10. IP code.
11. Modification number for any factory-ordered mods.
12. Insulative voltage rating