CI532V03 3BSE003828R1 ABB Card industrial control automation system

Description

CI532V03 Do not forcibly insert or disassemble the module. This may lead to PLC blockage or failure
Personal injury and damage to the module or base plate. Similarly, try to forcibly insert the module into an inappropriate slot
It will also cause damage to the module and/or substrate. The module will be easily installed with only a small amount of force
In a correct slot.

When inserting a module into the base plate slot, please use the following instructions as a guide for CI532V03.
■ Check whether the module catalog number matches the slot configuration. During configuration, each slot should be assigned a detailed module class
The power module must and can only be installed on the left unmarked slot, CPU module and some special option modules
The block can only be installed in slot 1 of the CPU base plate. I/O modules and most optional modules are installed in slot 2 and higher
Medium..
■ Grasp the module steadily, with the terminal panel facing towards itself and the pivot hook facing away from itself.
■ Arrange the modules on the base plate slot and connector you want to install. Tilt the module up so that the pivot hook at the top of the module is clamped
On the module holder on the top of the base plate.
■ Swing the module down until the connector of the module snaps into the bottom connector of the base plate, and the release lever at the bottom of the module snaps
When the bottom of the base plate is gripped, the module installation is completed.
■ Check that the module is firmly fixed.
Do not insert or remove the module with power. This will cause PLC stop or failure, and may cause personal injury
Harm or damage the module or base plate. Similarly, although the power supply of the rack has been cut off, the potential danger in the user’s device
The danger voltage may also exist in the CI532V03 fixed terminal of the module. Handle the module at any time and remove the terminal
Be careful when connecting the panel or any wiring connected to the panel.
■ If the module has been wired, remove the terminal panel of the module (note: you do not need to remove the terminal panel wiring) or the cable
The process of removing the terminal panel will be described later.
■ Look for the release lever at the bottom of the module and press it firmly towards the module.
■ When firmly holding the top of the module, fully press the release lever and shake the module upward (the release lever must be separated from the fixed slot).
■ Move the module up to disengage the rear top of the module from the pivot hook and away from the base plate.
When the PLC is running, if the power supply of the extension or remote base plate is powered down at this time, the power supply of the extension or remote base plate can be
Add, remove or replace modules on the process base plate. However, when the power supply fails, the transmission and connection of this substrate
The I/O data received will not be updated.
Install the template terminal board
Note: Modules IC693MDL730F (or later) and IC693MDL731F (or later) are equipped with special fixing
Screw terminal panel. For installation and removal instructions, refer to “Installation and removal of terminal panel with fixing screws” later in this chapter
part.
Install the terminal panel (refer to the following figure):
■ Attach the pivot hook at the bottom of the terminal CI532V03 panel ¦ Hook in the lower part of the module.
■ Push the terminal panel facing the module until it snaps into place.

Details: If you need urgent delivery orders, please feel free to contact us, and we will try our best to meet your needs.
Price problem: If you find that other suppliers offer cheaper prices for the same product, we are also willing to provide you with reference prices and give you further discounts.
Contact us:+86 180 6092 3929
Mail: 2235954483@qq.com
Contact: Chen