ECS086329-003 ABB Drive unit power supply

Description

ECS086329-003 This flash message is displayed under certain

conditions when attempting to assign logic input

functions under S3 LOGIC INPUTS. Only the “Disabled”

and “To FlexLogic” functions can ECS086329-003 be assigned to more

than one logic input. If an attempt is made to assign

any another function to a logic input when it is already

assigned to another logic input, the assignment will

not be made and this message will be displayed,

(b) Ground Input Selection settings also use this flash

message.

INVALID KEY: MUST

BE IN LOCAL MODE

This flash message is ECS086329-003 displayed in response to pressing

RESET while the 745 is in remote mode. The 745 must

be put into local mode in order for this key to be

operational.

INVALID SERIAL

NUMBER

This flash message is displayed when an attempt is

made to upgrade installed options and the 745 detects

an invalid serial number.

NEW PASSCODE HAS

BEEN STORED

This flash message is displayed in response to

changing the programmed passcode from the

setpoint S1 745 SETUP  PASSCODE  CHANGE

PASSCODE. The directions to change the passcode

were followed correctly, and the new passcode was

stored as entered.

NEW SETPOINT HAS

BEEN STORED

This flash message is ECS086329-003 displayed in response to pressing

ENTER while editing on any setpoint message. The

edited value was stored as entered.

NO ACTIVE TARGETS

(TESTING LEDS)

This flash message is displayed in response to the

MESSAGE UP or DOWN key while the Message LED is

off. There are no active conditions to display in the

target message queue.

OUT OF RANGE –

VALUE NOT STORED

This flash message is displayed in response to pressing

ENTER while on a setpoint message with a numerical

value. The edited value was either less than the

minimum or greater ECS086329-003 than the maximum acceptable

value for this setpoint and, as a result, was not stored.

PASSCODE VALID –

OPTIONS ADJUSTED

This flash message is displayed when an attempt to

upgrade an option was successful.

PLEASE ENTER A

NON-ZERO PASSCODE

This flash message is displayed while changing the

passcode from the S1 745 SETUP  PASSCODE 

CHANGE PASSCODE setpoint. An attempt was made to

change the passcode to “0” when it was already 0.

PRESS [ENTER] TO

ADD AS DEFAULT

This flash message is displayed for 5 seconds in

response to pressing the decimal key followed by

ENTER while displaying any setpoint or actual value

message except the S1 745 SETUP  DEFAULT

MESSAGES  SELECTED DEFAULTS setpoint. Pressing

ENTER again while this ECS086329-003 message is displayed adds the

setpoint or actual value message to the default list.

Details: If you need urgent delivery orders, please feel free to contact us, and we will try our best to meet your needs.
Price problem: If you find that other suppliers offer cheaper prices for the same product, we are also willing to provide you with reference prices and give you further discounts.
Contact us:+86 180 6092 3929
Mail: 2235954483@qq.com
Contact: Chen