3BSE001440R1 CI570 ABB module controller sensing equipment

Description

I/O template CI570 terminal board post
Note that there are three posts on the left side of the terminal panel. The top and bottom posts are used to fix the terminal panel cover. The middle posts are used to
Ensure the wiring of the terminal panel. If the user does not need it to fix the wiring, the middle pole can be easily removed
The middle marker can be removed with a small force. If you use it to keep the wiring firm, then when you remove the middle marker

Great care should be taken when making rods)
CI570 Installing and removing terminal panel with fixing screws
Digital output module IC693MDL730F (and later versions) and IC693MDL731F (and later versions) have special configurations
The terminal panel with fixing screws is shown in the figure below. These screws are used to prevent PLC from encountering severe vibration
The connection of the terminal panel to the module is affected.
Install the base plate on the panel
■ Use 4 high-quality (anti-corrosion) 8-32 x 1/2 (4 x 12 mm) mechanical screws to lock the washer and gasket. Mounting screw
Thread into the four movable bolt holes. Chapter 3 “Base plate” has applicable CI570 dimensions and installation clearance. (Accordingly, 10 slot base plate can
Mount on a standard 19 inch baseplate using a suitable adapter. These are discussed in the next section).
■ The vertical installation direction is the preferred method for maximum heat dissipation. Other installation directions need to reduce the power supply current capacity. Please refer to
See Chapter 3 “Rated load, stability and installation position” for more information on this.
■ All baseplates must be grounded. Details are provided in the “Baseplate Safe Grounding” section of this chapter.
■ The rack number selector switch must be set on each expansion or remote base plate. The CPU base plate does not need a switch. The rack number shall be
Assigned by the system designer. The wrong setting of the rack number selector switch will lead to system failure. See the chapter “Base plate” for details
Details of the setting switch.
Mounting the base plate on a 19 inch rack
Two optional baseplate adapter brackets allow 10 slot baseplates to be mounted to 19 inch racks. Only one adapter is required for each baseplate installation
Device support.
■ IC693ACC308 front mounting adapter bracket: CI570 installs the adapter bracket in front of the 19 inch rack
Install the adapter bracket from the pins at the top and bottom of the adapter bracket to the corresponding slots at the top and bottom of the plastic substrate housing. Note
Meaning: Although the plastic substrate shell shown in the figure below has been removed, this is for illustration purposes only. The mounting bracket does not
It is necessary to remove the housing. After the bracket is in place, insert and fix two screws (including the bracket) through the back of the baseplate hole
The face enters the threaded hole of the bracket.

Details: If you need urgent delivery orders, please feel free to contact us, and we will try our best to meet your needs.
Price problem: If you find that other suppliers offer cheaper prices for the same product, we are also willing to provide you with reference prices and give you further discounts.
Contact us:+86 180 6092 3929
Mail: 2235954483@qq.com
Contact: Chen