Bently Nevada 125800-02 3500 TMR configuration

Description

Handling and Storing Considerations

Circuit boards contain devices that are susceptible to damage when exposed to

electrostatic charges. Damage caused by obvious mishandling of the board will

void the warranty. To avoid damage, observe the following precautions:

Application Alert

Host communication

and rack configuration

capabilities will be lost

when this module is

removed from the rack.

ï Do not discharge static electricity onto the circuit board. Avoid tools or

procedures that would subject the circuit board to static damage. Some

possible causes include ungrounded soldering irons, nonconductive plastics,

and similar materials.

ï Personnel must be grounded with a suitable grounding strap (such as 3M

Velostat No. 2060) before handling or maintaining a printed circuit board.

ï Transport and store circuit boards in electrically conductive bags or foil.

ï Use extra caution during dry weather. Relative humidity less than 30% tends

to multiply the accumulation of static charges on any surface.

ï When performed properly, this module may be installed into or removed from

the rack while power is applied to the rack. Refer to the Rack Installation and

Maintenance Manual (part number 129766-01) for the proper procedure.

Disposal Statement

Customers and third parties, who are not member states of the European Union,

who are in control of the product at the end of its life or at the end of its use, are

solely responsible for the proper disposal of the product. No person, firm,

corporation, association or agency that is in control of product shall dispose of it

in a manner that is in violation of any applicable federal, state, local or

international law. Bently Nevada LLC is not responsible for the disposal of the

product at the end of its life or at the end of its use.

The Rack Interface Module (RIM) is the primary interface into the 3500 rack. It

supports a Bently Nevada proprietary protocol used to configure the rack and

retrieve machinery information. The RIM must be located in slot 1 of the rack

(next to the power supplies). The RIM provides the connections needed to

support current Bently Nevada Communications Processors (Transient Data

Interface External (TDIX) and Dynamic Data Interface External (DDIX)).

Although the RIM does provide certain functions common to the entire rack, the

RIM is not part of the critical monitoring path. The RIM’s operation (or non

operation) has no effect on the proper, normal operation of the overall

monitoring system.

For TMR applications, the 3500 system requires a TMR version of the RIM. In

addition to all the standard RIM functions, the TMR RIM also performs “monitor

channel comparison.” The 3500 TMR configuration executes monitoring voting

using the setup specified in the monitor options. Using this method, the TMR

RIM continually compares a specified output of 3 redundant monitors. If the

TMR RIM detects that the information from one of those monitors is no longer

equivalent (within a configured percent) to the remaining two, it will flag the

monitor as being in error and place an event in the System Event List.

Statuses

The Rack Interface Module returns both module and channel statuses. This

section describes the available statuses and where they can be found.

Module Status

OK

This indicates if the Rack Interface Module is functioning correctly. A not OK

status is returned under any of the following conditions:

ï Hardware Failure in the module

ï Communication Failure with any module

ï If any of the following security options have been configured and their

conditions met:

Rack Address is changed while the RIM is in Run Mode.

A module was inserted into or removed from the rack.

Details: If you need urgent delivery orders, please feel free to contact us, and we will try our best to meet your needs.
Price problem: If you find that other suppliers offer cheaper prices for the same product, we are also willing to provide you with reference prices and give you further discounts.
Contact Us:+86 18106937731
Whatapp:+86 15359293870
Email: geabbdcs@gmail.com / 2872270648@qq.com
Contact Person: Chen