NI-9174 cDAQ-9174 chassis power supply

Description

IEEE 488 Compatibility

The GPIB-140A, GPIB-140A/2, and GPIB-130 bus extenders are compatible with both IEEE 488.1 and IEEE 488.2. Unlike other extenders that respond to all GPIB addresses during the Find All Listeners protocol, this operation occurs normally with the GPIB-140A and GPIB-140A/2

CE compliance
This product meets the basic requirements of applicable European directives, as follows:
2006/95/EC; Low voltage command (safe)
2004/108/EC; Electromagnetic Compatibility Directive (EMC)

Cables
T7 cable for GPIB-140A (up to 1 km)
10 m………………………………………………………………………..182805-010
50 m………………………………………………………………………..182805-050
100 m………………………………………………………………………182805-100
500 m………………………………………………………………………182805-500
1000 m ……………………………………………………………………182805-01K
T8 cable for GPIB-140A/2 (up to 2 km)
100 m………………………………………………………………………183164-100
200 m………………………………………………………………………183164-200
500 m………………………………………………………………………183164-500
1000 m ……………………………………………………………………183164-01K
2000 m ……………………………………………………………………183164-02K
T2, T5, and T6 cables for GPIB-130 ……………………………..See page 710

The performance depends on the type of C-series I/O module installed and the number of channels in the task.
2 does not include group delay. For more information, please refer to the documentation for each C-series I/O module.
3 does not include group delay. For more information, please refer to the documentation for each C-series I/O module.
The actual signal available depends on the type of C-series I/O module installed.
5 includes a maximum module load of 1 W per slot within the rated temperature and product variation range.
When the session is active, regardless of the number of NI-XNET modules in the chassis, the CAN or LIN (NI-XNET) C-series modules use a total of two data streams.
When operating cDAQ-9174 at temperatures below 0 ° C, PS-15 power supply or other power supply with a rated temperature below 0 ° C must be used.