RLX2-IHNF-A ProSoft Industrial Hotspot Communication Gateway

Description

RLX2-IHNF-A technical parameters:
Rated power kVA 3-30
Input voltage range V 320~440
Output voltage V 380
Output voltage protection value V 426 ± 7
Response time s<0.1
Insulation resistance M Ω ≥ 5
Audio noise dB<50
Voltage stabilization accuracy V ± 1%
Output voltage distortion ≤ 5%
Load power factor 0.8
Overall efficiency>90%
Peak interference suppression input 1000V, 10 μ Peak pulse with output residual voltage less than 40V

RLX2-IHNF, RLX2-IHA, RLX2-IHG, RLX2-IHW

1. This equipment is Suitable For Use in Class I, Division2, Groups A, B, C, D or Non-Hazardous Location Only.
2. WARNING – EXPLOSION HAZARD – Substitution of Any Components May Impair Suitability for Class I, Division 2.
3. WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has been removed or the area is known to be non-hazardous.
4. The unit is to be connected only to PoE networks without routing to the outside plant.
5. WARNING – EXPLOSION HAZARD – The SIM Card/Personality Module connection is for initial setup and maintenance only. Do not use, connect, or disconnect unless area is known to be non-hazardous. Connection or disconnection in an explosive atmosphere could result in explosion.
6. Device must be powered by a Class 2 Power Source.
7. Device is an open-type and is to be installed in an enclosure suitable for the environment.

For RLX2-IHNF-WC Radios
This radio is suitable for Class I, DIV2 hazardous locations. This radio contains a set of wires that protrude through a single conduit hub. One wire is terminated with an RJ45 connector for Ethernet connections. This wire can also supply power if attached to a PoE Injector. The second wire supplies power to the radio if a PoE Injector is not used. If not using these cables, simply terminate them. To install this radio….
1. Place a Seal Cap over the top of the conduit.
2. Run both wires down through the conduit.
3. Push the conduit up into the permanently installed connector on the bottom of the radio. Push it up as far as it will go.

Model Standards Maximum Output Power
RLX2-IHA IEEE 802.11a 24 dBm (250 mW)
RLX2-IHG IEEE 802.11b/g 24 dBm (250 mW)
RLX2-IHNF IEEE 802.11a/b/g/n 17 dBm (50 mW)
RLX2-IHNF-W IEEE 802.11a/b/g/n 17 dBm (50 mW)
RLX2-IHNF-WC IEEE 802.11a/b/g/n 17 dBm (50mW)
RLX2-IHW IEEE 802.11a/b/g 20 dBm (200 mW)