Servo Driver 1394C-SJT22-T-RL

The product described in this manual is intended for use in an industrial environment.
To meet CE requirements, the following additions are required:
• You must run three-phase input wiring in a conduit that is grounded to the enclosure.
• You must install a power line filter (Allen-Bradley catalog number SP-74102-006-01, SP-74102-006-02, SP-74102-006-03 or equivalent based on system current) between the three-phase input line and the system module input.
• You must terminate the shields of the motor power cables and the motor feedback cables to the enclosure at the point of entry.
Low Voltage Directive
These units are tested to meet Council Directive 73/23/EEC Low Voltage Directive. The EN 60204-1 Safety of Machinery Electrical Equipment of Machines, Part 1-Specification for General Requirements standard applies in whole or in part.
Refer to Appendix B for interconnect information.
Before Mounting Your System Before you mount your 1394 system make sure you understand the following:
• how to store your 1394 before installation
• how to unpack the system and axis modules
• the minimum mounting requirements
• how to determine your mounting hole layout Storing Your 1394 Before Installation The 1394 System module and Axis modules should remain in their shipping containers prior to installation. If the equipment is not to be used for a period of time, store it as follows:
• Store the equipment in a clean, dry location that is not exposed to a corrosive atmosphere.
• Do not store equipment in a construction area.
• Store within an ambient temperature range of 0 to 65° C (32 to 149° F).
• Store within a relative humidity range of 5 to 95%, noncondensing.